![]() For more details on the springs for a Wayne Dalton Torquemaster system, check out our Wayne Dalton Torquemaster Springs page. In addition to the differences in the design to the cones would also be the types of springs used on these systems. Notice also that the ends of the Torquemaster I winding cones are round, and that the ends of the Torquemaster II winding cones are hexagonal. The Original Torquemaster system uses raised grooves on the cone to connect to the winding unit, while the Torquemaster Plus system has divits in the cone to accomplish the same purpose. One noticable difference in the Torquemaster systems is the winding cones. The Torquemaster II system parts include, from left to right: winding bracket, left cable drum, left winding cone, support bracket, right winding cone, right cable drum, and right winding bracket. This system uses cable drums that are compatable with the Original Torquemaster system as well as the same bracket, but it uses fewer parts overall. 721" ID oil tempered springs were replaced with. Wayne Dalton also introduced the Torquemaster Plus system pictured above it is also called the Torquemaster II system. If those are the only broken parts on your spring system, you can roll a piece of paper or cardboard and insert it into the end of your spring cone to count the number of turns as you wind the spring. We are removing the plastic cones from our list below as inventories diminish.Ĭounter wheels and counter gears have also been discontinued. 721" ID springs with with the steel cones for. You cannot replace the plastic cones for. 65" inside diameter and the steel winding cones. If you need a cone that is not on the list below, you will need to install a new spring with the. If you are ordering new springs, the new steel cones will come installed in the ends of the springs you do not need to order cones with your new springs. ![]() 721" inside diameters and the plastic cones for these are no longer made. The cable drums were replaced with the new drums that are backward compatible. Most of these parts are no longer available.Īs of 2012 Wayne Dalton stopped making many of the original Torquemaster One parts. Garage Door Opener Brands +1 81 State Line Door & Lift is your go-to company for all things garage door We provide expert installation, repair or. From left to right, the parts included: left winding bracket, left counter, counter gear, drive gear, left cable drum, left winding cone, support bracket, right winding cone, right cable drum, drive gear, winding gear, right counter, and right winding bracket. The Original Torquemaster system pictured above with the newer drums was used with two Torquemaster torsion springs. Wayne Dalton's Original Torquemaster system, pictured above but with the new style drums, also called the Torquemaster One system, used special hardware compatable with Wayne Dalton's Torquemaster torsion springs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |